QLS Installation

QLS Installation

QLS Installation

QLS Installation

Thank you for Purchasing our Deadly Customs QLS. Our QLS is Injection molded nylon is used in the construction of our quick locking system. The receiver plate can be attached at different angles according to user preference. The system allows for a quick transfer of gear between attachment points.

Part 1 Holster side 

Step 1 for QLS Installation.

Insert the 3 screw posts through the holes as per the picture.

Step 2

Add the 3 included rubber washers over the top of the screw posts.

Step 3

Place the fork over the 3 screw posts

Step 4

Add the provided metal washers and the tapered head screws to complete this part of the QLS Installation.

We suggest doing this nice and tight to compress the rubber washers.

 

Part 2 Mid Ride Side

Step 1

Add the 2 spiked T posts to the QLS receiver,

then add the 2 rubber washers on the back side as pictured.

Step 2

Place the mid ride over the 2 screw posts,

Step 3

Screw the 2 included screws into the screw posts.

We suggest doing this nice and tight to compress the rubber washers.

Step 4

Add the leg strap, take care to slot the screw post through the grommet on the strap. Add the last screw and tighten it down. We suggest using a dab of lock tight on the screw holding in the leg strap.

If you require another mount they can be purchased from your chosen retailer or directly from Deadly Customs by clicking here.

 

Visit our Facebook page www.facebook.com/deadlycustoms